20A UM001 EN P PDF

Rockwell Automation Publication 20A-TDJ-EN-P – July PowerFlex 70 Adjustable Frequency AC Drive User Manual, publication 20A-UM Publication 20A-INB-EN-P. The PowerFlex 70 drive contains protective MOVs and Common Mode. Capacitors referenced to ground (see below). To guard. posts; United States. Posted 1 Jun ยท llautomation. com/idc/groups/literature/documents/um/

Author: Mura Vudosida
Country: Chile
Language: English (Spanish)
Genre: Literature
Published (Last): 21 March 2015
Pages: 452
PDF File Size: 10.40 Mb
ePub File Size: 8.88 Mb
ISBN: 635-4-50063-318-6
Downloads: 79452
Price: Free* [*Free Regsitration Required]
Uploader: Shacage

Press the Enter key to display the Start-Up Menu. Enter text from picture: You can Upload the parameters from the drive to the HMI Sign up for a new account in our community.

Drive Stopped Check parameter [Start Inhibits]. Steady Drive running, no faults are present. Posted 1 Jun Share this post Link to post Share on other sites.

I suspect when you say “how to put original parameters to the new one”, you want to program a new drive with the same parameters as an existing drive. If the Safe-Off board is removed from the drive, pins 3 and 4 of the Safe-Off Connector must be jumpered for the drive to run. Extra jumpers or jumpers that have been removed should be stored 220a this location for use at a later time.

I have some questions about replacing PowerFlex The cause must be corrected before the fault can be cleared. Install original HMI on the new drive? If you have an LCD HIM, two methods are provided, allowing the user to select the desired level needed for the application.


Page 40 Running S. Rn luck and be careful.

Rockwell Automation 20A PowerFlex 70 Adjustable Frequency AC Drive User Manual

Allen-Bradley Drives Technical Support. How to replace PowerFlex 70? Not Selected Main Menu: Do not reduce wire gauge when using higher temperature wire.

Posted 31 May Start During a ; Up, the majority of applications require changes to only a few parameters. With these parameters, you can set the following functions Deutsch Dieses Instruktionsblatt kann in mehreren Sprachen unter http: To print the manual completely, please, download it.

Yellow Flashing, An inhibit condition exists, the drive cannot be started. Sign in Already have an account? When prompted, select a display language.

The information provided Does Not replace the User Manual and is intended for qualified drive service personnel only. The drive has been listed by U. If present, simply remove the protective cover, install or remove jumper and replace cover. Create an account or sign in to comment You need to be a member im001 order to een a comment Create an account Sign up for a new account in our community.


Table of Contents Add to my manuals Add.


Then put that HMI into the new drive and Download the parameters into the new drive. Don’t show me this message again. Also you should remove the HMI first before trying to remove the cover of that drive. Powerflex series medium voltage ac drives pages. Posted 4 Jun It is very easy to do.

Page of 52 Go. Hm001 status of this input is interpreted by drive software. If the application requires the drive to be disabled without software interpretation, a hardware enable configuration can be utilized. 200a drives will have a jumper storage area inside the front cover. Sign In Sign Up.

Forgive me but it sounds like you don’t have much experience with VFD’s Refer to user manual You need to be a member in order to leave a comment. Rockwell Automation distributor or sales representative. The information provided Does Not replace the User Manual and is.

work_outlinePosted in Travel