ASTM E1155 PDF

A commonly used standard to quantify finished quality of elevated and slabon- ground slabs is the ASTM Standard E The procedure outlines the method of . slab-on-ground slabs is the ASTM Standard, ASTM E The procedure outlines the method of profiling finished concrete to determine the flatness (FF) and. ASTM E Standard Test Method for Determining FF Floor Flatness and FL Floor Levelness Numbers.

Author: Tausho Kesar
Country: Italy
Language: English (Spanish)
Genre: Relationship
Published (Last): 15 October 2016
Pages: 189
PDF File Size: 7.15 Mb
ePub File Size: 9.34 Mb
ISBN: 388-2-15609-200-4
Downloads: 16258
Price: Free* [*Free Regsitration Required]
Uploader: JoJotaur

A simple workflow from importing the files to producing a report of the surface deviation analysis. Construct a polygon line around the area shown below. Qstm a Report from the Analysis The command will automatically build a standard report.

Lines are created to represent runs with traditional equipment. When prompted specify a location and name for the PDF report.

These notes and footnotes excluding those in tables and figures shall not be considered as requirements of this test method. Create Lines for Each Run Next we will create a line for each run, the s1155 result will appear as shown: By now you should have a grasp of the following:.

Repeat for several runs, as shown above. Historical Version s – view previous versions of standard. In those instances when the traffic across a floor will be confined to specific paths, however, the requirement for random sampling is eliminated, since the floor can indeed be inspected exactly as it will be seen by all of the traffic. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

  DESCARGAR EL SATIRICON PDF

A simple w orkflow from importing the files to producing a report of the surface deviation analysis. Referenced Documents purchase separately The documents listed below are referenced within the subject standard e11555 are not provided as part of the standard.

In these special cases, rather than inferring the condition of the traffic paths from a random sample, it is far more useful to measure each of the traffic paths directly using continuous recording floor profilometer configured to run exactly in the traffic wheel paths.

Select a start point and then select an end point for the first line. Link to Active This link will always route to the current Active version of the standard. Use the defaults for this exercise.

Module Floor Flatness and Level ASTM E with BuildIT Construction – FARO┬« Knowledge Base

No other units of measurement are included in this standard. Split cloud Creating lines representing a run. Such direct simulation measurements eliminate the inherent uncertainties of statistical sampling and provide profile information immediately applicable to the correction of the surface in way of the future traffic. Select all the sample lines.

Next we will create a line for each run, the end result will appear as shown: If you would like to download the file used in this article, download the accompanying Training Data and extract its contents to a folder on your PC.

  A7W SMD TRANSISTOR DATASHEET PDF

To avoid errors, save the current project before attempting the Floor Flatness Analysis. Click on the Report tab and click on Generate Report. When the traffic patterns across a floor are random, as is generally the case evaluation of the floor’s F F Flatness and F L Levelness will necessarily involve a random sampling of the surface, since all of the infinite potential profiles to be seen by the traffic can not possibly be measured.

Split cloud down to the area to be analyzed. Line Panel for each completed line.

Module 6.2: Floor Flatness and Level ASTM E1155 with BuildIT Construction

Tutorial Download If you would like to download the file used in this article, download the accompanying Training Data and extract its contents to a folder on your PC. A complete metric companion to Test Method E has been developed, Test Method EM ; therefore, no metric equivalents are shown in this test method.

By now you should have a grasp of the following: